If you have problems during the execution of MRCC, please attach the output with an adequate description of your case as well as the followings:
  • the way mrcc was invoked
  • the way build.mrcc was invoked
  • the output of build.mrcc
  • compiler version (for example: ifort -V, gfortran -v)
  • blas/lapack versions
  • as well as gcc and glibc versions

This information really helps us during troubleshooting :)

Combining rest=1 and rest=2

  • Nike
  • Topic Author
  • Offline
  • Premium Member
  • Premium Member
More
6 years 1 week ago #535 by Nike
Combining rest=1 and rest=2 was created by Nike
Greetings!
If I want to do CC(6) with rest=2, but it crashes after CC(5), rest=2 starts all the way back from CC(2) and rest=1 will only give me CC(6) from the fort.16 of CC(5), without calculating CC(5)(6).

If a job crashes at CC(5), is there a way to get CC(5)(6) and CC(6) with only 1 run, using the fort.16 from the completed CC(5)?

With best wises!!
Nike

Please Log in or Create an account to join the conversation.

  • kallay
  • Offline
  • Administrator
  • Administrator
  • Mihaly Kallay
More
6 years 1 week ago #536 by kallay
Replied by kallay on topic Combining rest=1 and rest=2
Sorry, I do not understand. CC(6) with rest=2 should work. If it crashes, please post the output file.

Best regards,
Mihaly Kallay

Please Log in or Create an account to join the conversation.

  • Nike
  • Topic Author
  • Offline
  • Premium Member
  • Premium Member
More
6 years 1 week ago #545 by Nike
Replied by Nike on topic Combining rest=1 and rest=2
Dear Mihaly,
Sorry for taking so long to reply. I wanted to try again just to make sure the behavior I was describing was correct, but the cluster has been down all week.

I finally lost patience and ran on a different machine.
As I remembered before, rest=2 starts all the way back from CCSD and repeats the CCSD, CCSD(T), CCSDT, CCSDT(Q), CCSDTQ, and CCSDTQ(P) from before.

Ideally I'd be able to combine rest=2 with rest=1 and get CCSDTQP(H) and CCSDTQPH by reading in the CCSDTQP amplitudes and doing CC(5)(6) and CC(6) in a "rest=2" type way (ie. running the program just once).

Instead I have to use rest=1 with CC(5)(6), wait until it finishes and then run CC(6) with rest=1.


With best wishes,
Nike

Please Log in or Create an account to join the conversation.

  • kallay
  • Offline
  • Administrator
  • Administrator
  • Mihaly Kallay
More
6 years 1 week ago #546 by kallay
Replied by kallay on topic Combining rest=1 and rest=2
Dear Nike,
Currently the two-step procedure is the only option, rest=1 cannot be combined with rest=2 in one run.

Best regards,
Mihaly Kallay

Please Log in or Create an account to join the conversation.

Time to create page: 0.046 seconds
Powered by Kunena Forum